SGS-Tools - Полный каталог инструмента - 2013 EN

                                для размещения заказа - sgs@sgs-tool.ru

                                           S-Carb Roughing End Mills

                                                                   POS

                                                 RH

TOLERANCES (inch)      CUTTING  LENGTH     inch    SHANK   CORNER             EDP NO.              43CB
                      DIAMETER  OF CUT           DIAMETER  RADIUS  UNCOATED Ti-NAMITE-B
3/8 DIAMETER                            OVERALL                                                   FRACTIONAL SERIES
D1	= +0.000/–0.00035       D1      L2   LENGTH        D2       R                          (TiB2)           TECH INFO 71
D2	= h6
R = +0.000/–0.002        3/8       1        L1      3/8     .010   34300  34305                            NON-FERROUS
                         1/2     1-1/4              1/2     .030   34301  34306
1/2–5/8 DIAMETER         5/8     1-5/8   2-1/2      5/8     .030   34302  34307                               PLASTICS/COMPOSITES
D1	= +0.000/–0.00043     3/4     1-5/8   3-1/4      3/4     .030   34303  34308
D2	= h6                   1              3-3/4       1      .030   34304  34309
R = +0.000/–0.002                  2
                                            4
3/4–1 DIAMETER                           4-1/2
D1	= +0.000/–0.00051
D2	= h6
R = +0.000/–0.002

TOLERANCES (mm)        CUTTING  LENGTH     mm      SHANK   CORNER             EDP NO.             43MCB
                      DIAMETER  OF CUT           DIAMETER  RADIUS  UNCOATED Ti-NAMITE-B                    METRIC SERIES
8–10 DIAMETER                           OVERALL                                                               TECH INFO 71
D1	= +0,000/–0,009         D1      L2   LENGTH        D2       R                          (TiB2)
D2	= h6
R = +0,000/–0,050        8,0     19,0       L1      8,0      0,3   44300  44305
                         10,0    22,0               10,0     0,3   44301  44306
>10–18 DIAMETER          12,0    26,0     63,0      12,0     1,0   44302  44307
D1	= +0,000/–0,011       16,0    32,0     72,0      16,0     1,0   44303  44308
D2	= h6                  20,0    38,0     83,0      20,0     1,0   44304  44309
R = +0,000/–0,050                         92,0
                                         104,0
>18–20 DIAMETER
D1	= +0,000/–0,013
D2	= h6
R = +0,000/–0,050

                    END MILLS                                             END MILLS               51

                                        sgs@sgs-tool.ru
                                        www.sgs-tool.ru