SGS-Tools - Каталог для Европейских стран - 2014 EN

                                                   для размещения заказа - sgs@sgs-tool.ru

                                                            Speed & Feed Recommendations

         ZH1MCR, ZH1MCRS                 HARDNESS                 CUT     SPEED                    6                  FEED (mm/flute)   25
               Metric                     BRINELL                 Type    m/min                          10 12 20
                                                                                                 0.017                                 0.058
 HIGH TEMPERATURE ALLOY                 300                    Slot     21                    0.017  0.032 0.041 0.053              0.058
     A-286, Hastelloy, Haynes, Incoloy,  > 300                   Profile   27                    0.036  0.032 0.041 0.053              0.133
     Inconel, Rene, Udimet, Waspalloy                            Light     45                    0.012  0.075 0.091 0.120              0.040
                                                                  Slot     16                    0.012  0.024 0.029 0.037              0.040
                                                                 Profile   21                    0.026  0.024 0.029 0.037              0.093
                                                                 Light     34                           0.053 0.062 0.085

         SLOT                                          CUT TYPE                          LIGHT*         rpm = (1000 x m/min) / (3.14 x D1)
                                                        PROFILE                                         mm/min = (mm/flute) x rpm
ap = D1                                                                   ap = 1.5 x D1                 • maximum recommended depths shown
ae = D1                                  ap = 1.5 x D1                    ae = 0.05 x D1                • reduce speed and feed for materials harder
                                         ae = 0.5 x D1
                                                                                                         than listed
                                                                                                        • * finish cuts typically require reduced feed and cutting depths

                                                                                                           of 0.02 x D1 maximum
                                                                                                        • refer to the SGS Tool Wizard for more complete technical

                                                                                                         information (available at )
                                                                                                        • Max. ramp angle = 6° / Max. ramp depth = 1xD

                                                                                                         (reduce feed accordingly)

                                                                                                        END MILLS                             27

                                                   sgs@sgs-tool.ru www.sgs-tool.ru