SGS-Tools - Инструмент для обработки композитных материалов - 2013 EN

                                                             для размещения заказа - sgs@sgs-tool.ru

    Series 25 Compression Router

    SERIES 25 COMPRESSION ROUTER – FOR FINISH MILLING OF CFRP
    A major challenge in machining with Composite material is preventing separation of material
    layers during the machining process. By incorporating both a left and right hand helix, the cutting
    pressure to the center of the work piece is compressed, eliminating the fraying of the material.

       •	 A left handed helix directs cutting forces downward in a pushing action, great for holding
           parts securely against a fixture.

       •	 A right handed helix directs cutting forces upward in a pulling action, great for chip
           evacuation.

       •	 The lower portion of the flute directs loads upward and the upper portion of the flute
           directs loads downward, minimizing the forces which cause delamination and fraying.

       •	 Available with Di-NAMITE coating for longer, cleaner performance
       •	 	Specialized geometry for maximum load reduction

                                                              Performance by Design
                                                                     Incorporates both a left and
                                                                     right hand helix, eliminating
                                                                     the fraying of material.

14  sgs@sgs-tool.ru
    www.sgs-tool.ru