SGS-Tools - Z-CarbHPR - Фрезы для черновой обработки - 2015 EN

                                           для размещения заказа - sgs@sgs-tool.ru

CAPABILITIES

RAMPING                                    ROUGHING                                                 HIGH-SPEED MACHINING

• Typical ramp angles of 5 degrees         • One times diameter slotting                            • Variable geometry design and
  are common; greater than                   capability is typical                                    open fluting eliminate vibration
  5 degree ramp angles are obtain-                                                                    to enable increased rates for
  able with reduced feed rates             • 50% radial by 150% axial heavy                           High Speed Machining
                                             profiling capability is common
• Entry feed rates can achieve                                                                      • Exclusive Ti-NAMITE-M coating
  100% of the slotting value                                                                          for higher heat resistance to
                                                                                                      enhance tool life
• The open center provides an
  ideal exit for central coolant and
  chip flushing while maintaining
  the 5 degree ramp angle

                               LAB TESTING RESULTS – HEAVY PROFILING IN TITANIUM

                         1400  1287
                         1200
                                     1179

USAGE (INCHES)           1000              504                                                                                      SGS Z5
                          800                                                                                                       Competitor A
                          600                                                                                                       Competitor B
                                                                                                                                    Competitor C

                         400                    324 324                                                                             Competitor D

                         200 Competitor E
                                                                                                                                               59

                            0

                         RESULTS IN TITANIUM 6AL4V @ 32HRC Z5CR 1/2" TESTED AT 1643 RPM X 16.4 IPM
                         .250" RADIAL WIDTH OF CUT X .750” AXIAL DEPTH OF CUT

                         FIELD TESTING RESULTS – TITANIUM METAL REMOVAL FEED RATES

                         7.0 800%                                                                         PRODUCTIVITY IMPROVEMENT

CUBIC INCHES PER MINUTE  6.0                                                                        700%                            SGS Z5

                         5.0                                                                        600%                            Metal Removal
                                                                                                                                    Rate
                                                                                                                                           500%
                         4.0 Competitor
                                                                                                    400%                            Metal Removal
                         3.0 Rate
                                                                                                                                           300%

                         2.0                                                                        200%                            Productivity
                                                                                                                                    Improvement

                         1.0 100%

                         0.0 0%

                                                sgs@sgs-tool.ru
                                                www.sgs-tool.ru