SGS-Tools - Полный каталог инструмента - 2014 EN

                                  для размещения заказа - sgs@sgs-tool.ru

                                                                                  S-Carb Roughing End Mills

                                                                           POS

                                                   RH

TOLERANCES (inch)       Cutting   Length     inch    Shank   Corner                   EDP No.               43CB
                       Diameter   of Cut           Diameter  Radius        Uncoated Ti-NAMITE-B
3/8 DIAMETER                              Overall                                                         Fractional Series
D1	= +0.0000/–0.00035       D1       l2   Length        D2       R                                (TiB2)           tech info 92
D2	= h6
R = +0.0000/–0.0020       3/8        1        L1      3/8     .020         34300  34305                            NON-FERROUS
                          1/2      1-1/4              1/2     .030         34301  34306
1/2–5/8 DIAMETER          5/8      1-5/8   2-1/2      5/8     .030         34302  34307                               PLASTICS/COMPOSITES
D1	= +0.0000/–0.00043     3/4      1-5/8   3-1/4      3/4     .030         34303  34308
D2	= h6                    1               3-3/4       1      .030         34304  34309
R = +0.0000/–0.0020                  2
                                              4
3/4–1 DIAMETER                             4-1/2
D1	= +0.0000/–0.00051
D2	= h6
R = +0.0000/–0.0020

TOLERANCES (mm)         Cutting   Length     mm      Shank   Corner                   EDP No.             43MCB
                       Diameter   of Cut           Diameter  Radius        Uncoated Ti-NAMITE-B                 METRIC Series
8–10 DIAMETER                             Overall                                                                  tech info 94
D1	= +0,000/–0,009          D1       l2   Length        D2       R                                (TiB2)
D2	= h6
R = +0,000/–0,050         8,0      19,0       L1      8,0      0,3         44300  44305
                          10,0     22,0               10,0     0,3         44301  44306
>10–18 DIAMETER           12,0     26,0     63,0      12,0     1,0         44302  44307
D1	= +0,000/–0,011        16,0     32,0     72,0      16,0     1,0         44303  44308
D2	= h6                   20,0     38,0     83,0      20,0     1,0         44304  44309
R = +0,000/–0,050                           92,0
                                           104,0
>18–20 DIAMETER
D1	= +0,000/–0,013
D2	= h6
R = +0,000/–0,050

                       END MILLS                                                  END MILLS               53

                                          sgs@sgs-tool.ru
                                          www.sgs-tool.ru