SGS-Tools - Полный каталог инструмента - 2013 EN

                                   для размещения заказа - sgs@sgs-tool.ru

                                    Speed & Feed Recommendations

        Diamond 1, 1B, 3, 3B        CUT     SPEED                1/8     1/4   FEED (inch/flute)    3/8     1/2
              Fractional            Type     sfm                                      5/16
                                                              0.00060  0.0016                     0.0030  0.0040
 ALUMINUM DIE CAST ALLOY*        Slot     290              0.00069  0.0018      0.0025         0.0035  0.0046
     (High Silicon)                Profile   360              0.00138  0.0037      0.0029         0.0069  0.0092
     A-390, A-392, B-390           Light     400              0.00030  0.0008      0.0057         0.0015  0.0020
                                    Slot     30               0.00035  0.0009      0.0013         0.0017  0.0023
CERAMIC*                           Profile   40               0.00069  0.0018      0.0014         0.0034  0.0046
Machinable                         Light     60               0.00075  0.0020      0.0029         0.0038  0.0050
                                    Slot     580              0.00087  0.0023      0.0031         0.0043  0.0058
GRAPHITE                           Profile   720              0.00172  0.0046      0.0036         0.0086  0.0115
Ultrafine, Superfine               Light     800              0.00045  0.0012      0.0072         0.0023  0.0030
                                    Slot     350              0.00052  0.0014      0.0019         0.0026  0.0035
COMPOSITE                       Profile   385              0.00103  0.0028      0.0022         0.0052  0.0069
     FRP, CFRP, GRP                Light     580              0.00075  0.0020      0.0043         0.0038  0.0050
                                    Slot     960              0.00087  0.0023      0.0031         0.0043  0.0058
PLASTIC                         Profile  1200              0.00172  0.0046      0.0036         0.0086  0.0115
     G10, PVC, PEEK, Phenolic      Light    1320                                   0.0072

           SLOT          CUT TYPE                     LIGHT*  rpm = sfm x 3.82 / D1
                          PROFILE                             ipm = (inch/flute) x no. of flutes x rpm
Rw = D1                                     Rw = .05 x D1
Ad = D1          Rw = .25 x D1              Ad = 1.5 x D1     *Diamond not intended for Aluminum Alloys or Ceramics
                 Ad = 1.5 x D1
                                                              • maximum recommended depths shown
                                                              • limit cut depths of long flute and extra long flute to .05 x D1 Ad

                                                                for Slot or Rw for Profile
                                                              * finish cuts typically require reduced feed and cutting depths of

                                                                .02 x D1 maximum
                                                              • refer to the SGS Tool Wizard for more complete technical information

                                                                (available at )

                 END MILLS                                                     END MILLS                          117

                                            sgs@sgs-tool.ru
                                            www.sgs-tool.ru