SGS-Tools - Полный каталог инструмента - 2013 EN

                                       для размещения заказа - sgs@sgs-tool.ru

                                                           Single End Roughers

                                                                          POS

                                                                  RH

TOLERANCES (inch)                      inch                                           EDP NO.                        61

D1	= +0.000/–0.004    CUTTING  LENGTH  OVERALL    SHANK   CORNER  NO. OF  Ti-NAMITE   Ti-NAMITE-C Ti-NAMITE-A  FRACTIONAL SERIES
D2	 = h6             DIAMETER  OF CUT  LENGTH   DIAMETER  RADIUS  FLUTES     (TiN)                                     TECH INFO 121
R	= +0.005/–0.005
                          D1      L2       L1        D2       R     3                                                   STEELS
                                                                    3                 (TiCN)   (AlTiN)                  STAINLESS STEELS
                       1/4*      3/4    2-1/2      1/4     .045     3                                                   CAST IRON
                                                           .045     4          36107  36106    36110
                     5/16* 3/4         2-1/2 5/16          .060     4          36109  36108    36111
                                                           .060     4          36113  36112    36114
                     3/8 7/8           2-1/2 3/8           .060     5          36117  36116    36118
                                                           .060                36121  36120    36222
                     1/2 1             3 1/2               .060                36125  36124    36126
                                                                               36129  36128    36130
                     5/8 1-1/4         3-1/2 5/8

                     3/4 1-5/8         4 3/4

                     1 1-3/4           41

                     *Without Flat

TOLERANCES h10 (mm)                    mm                                             EDP NO.                   61M

D1	= +0,000/–0,100    CUTTING  LENGTH  OVERALL    SHANK   CORNER  NO. OF  Ti-NAMITE   Ti-NAMITE-C Ti-NAMITE-A  METRIC SERIES
D2	 = h6             DIAMETER  OF CUT  LENGTH   DIAMETER  RADIUS  FLUTES     (TiN)                              TECH INFO 122
R	= +0,127/–0,127
                          D1      L2       L1        D2       R     3
                                                                    3                 (TiCN)   (AlTiN)
                        6,0     19,0    63,0       6,0     1,14     3
                        8,0     19,0                       1,14     4          46107  46106    46110
                       10,0     22,0   63,0 8,0            1,52     4          46109  46108    46111
                       12,0     26,0                       1,52     4          46113  46112    46114
                       16,0     32,0   72,0 10,0           1,52     5          46117  46116    46118
                       20,0     38,0                       1,52                46121  46120    46122
                       25,0     44,0   83,0 12,0           1,52                46129  46128    46132
                                                                               46131  46130    46133
                                       92,0 16,0

                                       104,0 20,0

                                       104,0 25,0

                    END MILLS                                                                 END MILLS        109

                                                sgs@sgs-tool.ru
                                                www.sgs-tool.ru