SGS-Tools - Каталог для Европейских стран - 2014 EN

                                                 для размещения заказа - sgs@sgs-tool.ru

                                                          Speed & Feed Recommendations

               ZD1MCR                  HARDNESS  CUT      SPEED        3                            FEED (mm/flute)
               Metric                   BRINELL  Type     m/min                   6 10 12 16 20

 STEEL                                         Slot 66 0.016 0.032 0.048 0.064 0.079 0.097
     TOOL STEEL
     MOLD & DIE STEEL                   420 Profile 81 0.023 0.046 0.066 0.089 0.112 0.135
     300M, 4340, 52100,
     HP 9-4-20, M-50,                            Light 171 0.028 0.056 0.084 0.112 0.140 0.168
     A2, D2, H13, L2, M2,
     P20, S7, T15, W2                            Slot 37 0.013 0.025 0.038 0.051 0.064 0.076

                                       > 420     Profile           46  0.018 0.036 0.053 0.071 0.089 0.107
                                        560

                                                 Light 149 0.023 0.046 0.066 0.089 0.112 0.135

                                                 Slot 20 0.010 0.020 0.028 0.038 0.048 0.058

                                       > 560     Profile           24  0.013 0.028 0.041 0.053 0.066 0.081
                                        655

                                                 Light 76 0.015 0.033 0.048 0.064 0.079 0.097

               SLOT                              CUT TYPE                                      LIGHT*  rpm = (1000 x m/min) / (3.14 x D1)
                                                          PROFILE                                      mm/min = (mm/flute) x rpm
                  > 560  655 Brinell                                              655 Brinell        • maximum recommended depths shown
 560 Brinell     ap = 0.3 x D1         560 Brinell      > 560  655 Brinell Rw  ap = 0.1 x D1        • reduce speed and feed for materials harder
ap = 0.5 x D1     ae = D1              ap = D1            ap = D1                 ae = 0.1 x D1
ae = D1                                ae = 0.5 x D1      ae = 0.3 x D1                                 than listed
                                                                                                       • * finish cuts typically require reduced feed

                                                                                                          and cutting depths of .02 x D1 maximum
                                                                                                       • refer to the SGS Tool Wizard for more

                                                                                                        complete technical information
                                                                                                        (available at )
                                                                                                       • Max. ramp angle = 6° / Max. ramp depth
                                                                                                        = 1xD
                                                                                                        (reduce feed accordingly)

                                                                                                       END MILLS     29

                                                 sgs@sgs-tool.ru www.sgs-tool.ru